Graphene Spin Flash Dryer Machine Graphite flash dryer

XSG spin flash dryer is one of the main products of Lead machinery. The hot air enters the dryer chamber from the bottom of the dryer host, it's going into the dryer chamber by the inlet entrance. The rotor at the conical base of the drying chamber fluidity products particles in a drying-efficient hot air flow pattern in which any wet lumps are rapidly disintegrated.
Using the heat from the air stream, the material dries as it is conveyed. Product is separated using cyclones, and/or bag filters.
Typically, cyclones are followed by scrubbers or bag filters for the final cleaning of the exhaust gases to meet current emission requirements.
Airborne, fine particles pass through a classifier at the top of the drying chamber, while larger particles remain in the airflow for further drying and powdering.

The hot air enters into the bottom of the dryer in tangent direction. Under the driving of the stirrer, a powerful rotating wind area is formed. The paste state materials enter into the dryer through the s crew charger. Under the powerful function effect of stirring at high-speed rotation, the materials are distributed under the function of s trike, friction and shearing force. The block state materials will soon be smashed and contact the hot air fully and the materials are heated and dried. The dried materials after the de-watering will go up with the hot-air flow. The grading rings will stop and keep the big particles. Small particles will be discharged out of the dryer from the ring center and will be collected in the cyclone and dust collector. The not-fully-dried or big piece materials will be sent to the wall of the equipment by centrifugal force and be smashed again after they fall down to the bottom.

1 Adopt 2 lines tangential air enter into volute at the best position, it will improve or remove blind Angle of wind and also the wind in the weak
2 Be good at controlling the powder's moisture, fineness, and hold time. for control the speed coordinating and unifying at spinning disk work with wind-enter, it can ensure the outlet wind with low temperature, it will also reduce the energy consumption.
3 The special alloy steel be used in the rotary blade, the layout structure with unique, it has the character of small erosion, contact surface wide, cutting force strong.
4 Adopt the newly leak-proof structure; the main engine bearing life will be delayed and the bearing black with the cooling device.
5 In order to ensure the powder water content is less than 0.5%, so increase the height than the original basis, it is also equipped with a spinning disk, which will make the powder quality and particle size meet your requirement.
Due to the gas-solid corresponding relative velocity big, even though the mix temperature is around 80~90ºC, the powder temperature is still below 45ºC condition, it will help to pack and save energy.

Parameters of spin flash dryer: